AIM CAN Extension Cable 712 -712

AiM 712-712 Male to Female 4-pin patch lead

Used to connect sensors to the Channel Expansion Hub, this cable can also extend the wiring of an existing component. The patch lead is commonly paired with the MXL Strada, MXL Pista, and EVO4 Data Logger to connect the Infrared lap timing receiver.

AiM 712-712 5-pin Male to 4-pin Female patch lead

Used as an extension cable for connection with MyChron5/5S and kart magnetic lap receiver, front or rear wheel speed sensor for kart.

AIM 712-712 Male to Female 5-pin CAN patch lead

Used to connect different AiM hardware components within the AiM-specific CAN system, which stands for Controller Area Network. These cables enable the transfer of both data and power between AiM modules and to link Channel Expansion Hubs, ECU Bridge, Lambda Controller, GPS module, and other peripheral hardware to a Data Hub, or from the Data Hub to the dash/logger harness. Different cable lengths are available to suit specific installation requirements.

AIM 712-712 5-pin Male to 7-pin Male CAN patch lead

Used to connect an AiM SmartyCam HD or SmartyCam HD GP to an AiM Dash, Logger, Solo2 DL lap timer, or Data Hub. The 712 5-pin male connector connects to the dash, logger, or data hub/CAN expansion, and the 712 7-pin male connector connects to the SmartyCam HD. The harness is available in 2 or 4-meter lengths. This harness allows the AiM SmartyCam HD to receive data from the AiM Dash, Logger, Solo2 DL lap timer, or Data Hub, and also provides power to the camera.